Skip to content
The People's CodeSearch
Menu

Changes to the Code

H.R. 9711 · Autocycle Safety Act ·

In committee · step 2 of 5

Sections are cited like “7 U.S.C. § 2012”: 7 of the , 2012.

49 U.S.C. § 30102 Definitions

+52 −50Shown
More for 49 U.S.C. § 30102
Read § 30102Only this section
2 changes the bill asks for here, 2 carried out
  1. Carried out:

    by redesignating paragraphs (1) through (13) as paragraphs (2) through (14), respectively; and

  2. Carried out:

    by inserting before paragraph (2), as redesignated, the following:(1) “autocycle” means a motorcycle with 3 wheels in contact with the ground, front-wheel drive, a fully enclosed occupant compartment, and a steering wheel, which is subject to applicable Federal motor vehicle safety standards, as determined necessary by the Secretary of Transportation through regulation..

§ 30102(a)–(b)

§ 30102. Definitions

(a) General Definitions.— In this chapter—

(1) [inserted: “autocycle” means a motorcycle with 3 wheels in contact with the ground, front-wheel drive, a fully enclosed occupant compartment, and a steering wheel, which is subject to applicable Federal motor vehicle safety standards, as determined necessary by the Secretary of Transportation through regulation.]

[struck: (1)] [inserted: (2)] “covered rental vehicle” means a motor vehicle that—

(A) has a gross vehicle weight rating of 10,000 pounds or less;

(B) is rented without a driver for an initial term of less than 4 months; and

(C) is part of a motor vehicle fleet of 35 or more motor vehicles that are used for rental purposes by a rental company.

[struck: (2)] [inserted: (3)] “dealer” means a person selling and distributing new motor vehicles or motor vehicle equipment primarily to purchasers that in good faith purchase the vehicles or equipment other than for resale.

[struck: (3)] [inserted: (4)] “defect” includes any defect in performance, construction, a component, or material of a motor vehicle or motor vehicle equipment.

[struck: (4)] [inserted: (5)] “distributor” means a person primarily selling and distributing motor vehicles or motor vehicle equipment for resale.

[struck: (5)] [inserted: (6)] “interstate commerce” means commerce between a place in a State and a place in another State or between places in the same State through another State.

[struck: (6)] [inserted: (7)] “manufacturer” means a person—

(A) manufacturing or assembling motor vehicles or motor vehicle equipment; or

(B) importing motor vehicles or motor vehicle equipment for resale.

[struck: (7)] [inserted: (8)] “motor vehicle” means a vehicle driven or drawn by mechanical power and manufactured primarily for use on public streets, roads, and highways, but does not include a vehicle operated only on a rail line.

[struck: (8)] [inserted: (9)] “motor vehicle equipment” means—

(A) any system, part, or component of a motor vehicle as originally manufactured;

(B) any similar part or component manufactured or sold for replacement or improvement of a system, part, or component, or as an accessory or addition to a motor vehicle; or

(C) any device or an article or apparel, including a motorcycle helmet and excluding medicine or eyeglasses prescribed by a licensed practitioner, that—

(i) is not a system, part, or component of a motor vehicle; and

(ii) is manufactured, sold, delivered, or offered to be sold for use on public streets, roads, and highways with the apparent purpose of safeguarding users of motor vehicles against risk of accident, injury, or death.

[struck: (9)] [inserted: (10)] “motor vehicle safety” means the performance of a motor vehicle or motor vehicle equipment in a way that protects the public against unreasonable risk of accidents occurring because of the design, construction, or performance of a motor vehicle, and against unreasonable risk of death or injury in an accident, and includes nonoperational safety of a motor vehicle.

[struck: (10)] [inserted: (11)] “motor vehicle safety standard” means a minimum standard for motor vehicle or motor vehicle equipment performance.

[struck: (11)] [inserted: (12)] “rental company” means a person who—

(A) is engaged in the business of renting covered rental vehicles; and

(B) uses for rental purposes a motor vehicle fleet of 35 or more covered rental vehicles, on average, during the calendar year.

[struck: (12)] [inserted: (13)] “State” means a State of the United States, the District of Columbia, Puerto Rico, the Northern Mariana Islands, Guam, American Samoa, and the Virgin Islands.

[struck: (13)] [inserted: (14)] “United States district court” means a district court of the United States, a United States court for Guam, the Virgin Islands, and American Samoa, and the district court for the Northern Mariana Islands.

(b) Limited Definitions.—

(1) In sections 30117(b), 30118–30121, and 30166(f) of this title—

Rest of § 30102 unchanged ·

49 U.S.C. § 30112 Prohibitions on manufacturing, selling, and importing noncomplying motor vehicles and equipment

+2 −2Shown
More for 49 U.S.C. § 30112
Read § 30112Only this section
2 changes the bill asks for here, 2 carried out
  1. Carried out:

    in paragraph (1), by striking sections 30113 and 30114 and inserting sections 30113, 30114, and 30114A; and

  2. Carried out:

    in paragraph (3), by striking section 30114, and inserting sections 30114 and 30114A,.

§ 30112(a)–(b)

§ 30112. Prohibitions on manufacturing, selling, and importing noncomplying motor vehicles and equipment

(a) General.—

(1) Except as provided in this section, sections 30113[inserted: ,] [inserted: 30114, ]and [struck: 30114][inserted: 30114A] of this title, and subchapter III of this chapter, a person may not manufacture for sale, sell, offer for sale, introduce or deliver for introduction in interstate commerce, or import into the United States, any motor vehicle or motor vehicle equipment manufactured on or after the date an applicable motor vehicle safety standard prescribed under this chapter takes effect unless the vehicle or equipment complies with the standard and is covered by a certification issued under section 30115 of this title.

(2) Except as provided in this section, sections 30113 and 30114 of this title, and subchapter III of this chapter, a school or school system may not purchase or lease a new 15-passenger van if it will be used significantly by, or on behalf of, the school or school system to transport preprimary, primary, or secondary school students to or from school or an event related to school, unless the 15-passenger van complies with the motor vehicle standards prescribed for school buses and multifunction school activity buses under this title. This paragraph does not apply to the purchase or lease of a 15-passenger van under a contract executed before the date of enactment of this paragraph.

(3) Except as provided in this section, [struck: section][inserted: sections] 30114[inserted: and 30114A], subsections (i) and (j) of section 30120, and subchapter III, a person may not sell, offer for sale, introduce or deliver for introduction in interstate commerce, or import into the United States any motor vehicle or motor vehicle equipment if the vehicle or equipment contains a defect related to motor vehicle safety about which notice was given under section 30118(c) or an order was issued under section 30118(b). Nothing in this paragraph may be construed to prohibit the importation of a new motor vehicle that receives a required recall remedy before being sold to a consumer in the United States.

(b) Nonapplication.— This section does not apply to—

(1) the sale, offer for sale, or introduction or delivery for introduction in interstate commerce of a motor vehicle or motor vehicle equipment after the first purchase of the vehicle or equipment in good faith other than for resale;

Rest of § 30112 unchanged ·

49 U.S.C. § 30114A Autocycles New section

+52 −0Shown
More for 49 U.S.C. § 30114A
1 change the bill asks for here, 1 carried out
  1. Carried out:

    by inserting after section 30114 the following:30114A. Autocycles (a) Interim safety standards for autocycles.— During the period beginning on the date of the enactment of the Autocycle Safety Act and ending on the effective date of the rules issued pursuant to subsection (b), a person satisfies the requirements set forth in section 30112(a) with regard to an autocycle if the autocycle— (1) complies with the motor vehicle safety standards for passenger cars, as set forth in part 571 of title 49, Code of Federal Regulations, relating to— (A) controls and displays (FMVSS 101); (B) lamps, reflective devices, and associated equipment (FMVSS 108), except for center high-mounted stop lamps; (C) brake systems (FMVSS 135); (D) seating systems (FMVSS 207); (E) belted occupant crash protection (FMVSS 208); and (F) seat belt assemblies (FMVSS 209); (2) complies with the motor vehicle safety standards for motorcycles, as set forth in part 571 of title 49, Code of Federal Regulations, relating to— (A) new pneumatic tires (FMVSS 119); and (B) tire selection and rims (FMVSS 120); (3) complies with the motor vehicle safety standards for motorcycles or passenger cars (at the option of such person), as set forth in part 571 of title 49, Code of Federal Regulations, relating to— (A) brake hoses (FMVSS 106); (B) rearview mirrors (FMVSS 111), except for inside rearview mirrors; (C) motor vehicle brake fluids (FMVSS 116); and (D) glazing materials (FMVSS 205); (4) meets the performance criteria relating to upper interior impact set forth in FMVSS 201 to the extent possible to reach the target points; and (5) is equipped with a steering wheel air bag, anti-lock brakes, and electronic stability control. (b) Rulemaking.— (1) In general.— Not later than 3 years after the date of the enactment of the Autocycle Safety Act, the Secretary of Transportation shall issue such final rules, interpretations, and test procedures in accordance with paragraphs (2) and (3) as may be necessary for a person to satisfy the requirements set forth in section 30112(a) with regard to an autocycle. (2) Determination.— In determining which motor vehicle safety standards are applicable to autocycles under paragraph (1), the Secretary shall— (A) apply appropriate motorcycle safety standards to those aspects of an autocycle’s performance that are appropriately regulated through the motor vehicle safety standards applicable to motorcycles; and (B) apply appropriate passenger car safety standards to those aspects of an autocycle’s performance regulated through motor vehicle safety standards that are not otherwise appropriately regulated through a motorcycle standard. (3) Other requirements.— In issuing rules to preserve autocycle safety pursuant to paragraph (1), the Secretary shall— (A) provide autocycle manufacturers with appropriate lead time to comply with the safety standards set forth in such rules; and (B) comply with the requirements and considerations set forth in subsections (a) and (b) of section 30111..

§ 30114A(a)–(b)

§ 30114A. [inserted: Autocycles]

(a) [inserted: Interim safety standards for autocycles.—] [inserted: During the period beginning on the date of the enactment of the Autocycle Safety Act and ending on the effective date of the rules issued pursuant to subsection (b), a person satisfies the requirements set forth in section 30112(a) with regard to an autocycle if the autocycle—]

(1) [inserted: complies with the motor vehicle safety standards for passenger cars, as set forth in part 571 of title 49, Code of Federal Regulations, relating to—]

(A) [inserted: controls and displays (FMVSS 101);]

(B) [inserted: lamps, reflective devices, and associated equipment (FMVSS 108), except for center high-mounted stop lamps;]

(C) [inserted: brake systems (FMVSS 135);]

(D) [inserted: seating systems (FMVSS 207);]

(E) [inserted: belted occupant crash protection (FMVSS 208); and]

(F) [inserted: seat belt assemblies (FMVSS 209);]

(2) [inserted: complies with the motor vehicle safety standards for motorcycles, as set forth in part 571 of title 49, Code of Federal Regulations, relating to—]

(A) [inserted: new pneumatic tires (FMVSS 119); and]

(B) [inserted: tire selection and rims (FMVSS 120);]

(3) [inserted: complies with the motor vehicle safety standards for motorcycles or passenger cars (at the option of such person), as set forth in part 571 of title 49, Code of Federal Regulations, relating to—]

(A) [inserted: brake hoses (FMVSS 106);]

(B) [inserted: rearview mirrors (FMVSS 111), except for inside rearview mirrors;]

(C) [inserted: motor vehicle brake fluids (FMVSS 116); and]

(D) [inserted: glazing materials (FMVSS 205);]

(4) [inserted: meets the performance criteria relating to upper interior impact set forth in FMVSS 201 to the extent possible to reach the target points; and]

(5) [inserted: is equipped with a steering wheel air bag, anti-lock brakes, and electronic stability control.]

(b) [inserted: Rulemaking.—]

(1) [inserted: In general.—] [inserted: Not later than 3 years after the date of the enactment of the Autocycle Safety Act, the Secretary of Transportation shall issue such final rules, interpretations, and test procedures in accordance with paragraphs (2) and (3) as may be necessary for a person to satisfy the requirements set forth in section 30112(a) with regard to an autocycle.]

(2) [inserted: Determination.—] [inserted: In determining which motor vehicle safety standards are applicable to autocycles under paragraph (1), the Secretary shall—]

(A) [inserted: apply appropriate motorcycle safety standards to those aspects of an autocycle’s performance that are appropriately regulated through the motor vehicle safety standards applicable to motorcycles; and]

(B) [inserted: apply appropriate passenger car safety standards to those aspects of an autocycle’s performance regulated through motor vehicle safety standards that are not otherwise appropriately regulated through a motorcycle standard.]

(3) [inserted: Other requirements.—] [inserted: In issuing rules to preserve autocycle safety pursuant to paragraph (1), the Secretary shall—]

(A) [inserted: provide autocycle manufacturers with appropriate lead time to comply with the safety standards set forth in such rules; and]

(B) [inserted: comply with the requirements and considerations set forth in subsections (a) and (b) of section 30111.]

Step through the changes